Technical Notes/Industry Trends2026-10-06

AM Powder Is Not the Same Product as Wrought Alloy

Both may be called 718, but powder-bed fusion uses spherical powder whose size, oxygen and porosity acceptance differs completely from forged bar. Mixing the two specifications invites trouble.

Alloy bars, tubes, wire and flanges grouped together

Additive manufacturing is advancing quickly in aerospace and energy, and powder demand is rising with it. But "718 for printing" and "718 for forging" are the same grade as two different products with very different acceptance.

Form and size

Powder-bed fusion (L-PBF) uses 15–53 μm spherical powder with good flowability and few satellite particles; directed energy deposition (DED) uses coarser cuts. Size distribution, apparent density and porosity directly affect printed density and defect rates.

Oxygen content is a hard criterion

Powder has a huge specific surface and picks up oxygen easily. High oxygen forms oxide inclusions in printed parts and clearly degrades fatigue. That is why powder ships vacuum- or inert-gas-packed, stored cool, with limits on reuse cycles.

Structure and heat treatment differ

As-printed structure is rapidly solidified fine grain with high residual stress and requires stress relief; wrought bar follows deformation plus solution and aging. The two cannot share one heat-treatment curve.

What this means for buyers

If your part goes the AM route, inquire by powder specification: size cut, oxygen content, sphericity, porosity, reuse policy. If wrought, inquire by bar specification: forging ratio, ultrasonic class, grain size. Mixing the two only buys a vague quote.

This article is a general technical note on materials and processing; cited standards are public standard numbers. Specific grades, sizes and acceptance items are subject to the technical agreement confirmed by both parties.

LET'S MAKE IT WORK

Match the material to your service conditions.

Submit a technical requirement